Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
Fusing current for a round wire is approximately is equal to
k d^3/2 Amps.d=dia in mm, k=80 for copper, 12.8 for tin and
59 for Al.Fusing factor =minimum fusing current/current
rating of fuse.This value should be more than one and is
usually two.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
why the rotor current becomes in steady state during high slip region? please verify with equations.
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
WHY BLADE & JOW OF ISOLETOR IN SUBSTATION?
Why in ESP Positive earthed
If the rated speed of a d.c. Shunt motor is1440 r.p.m, which method of speed control would you suggested to obtain a speed of 1500 r.p.m?
what is the use of expulsition protective gap in 11Kv line.
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
details of oil cell size of Breakdown voltage test of tranformer oil details as per Standardswith mushroom electrodes?
What is electrical diversity factor in electrical installations?
WHY MOSTLY Rph IS USED FOR CONTROL CIRCUITS AUX. SUPPLY ?
ht side line to earth voltage
List the advantages of star-delta starter with induction motor?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
