Interested to Buy Any Domain ? << Click Here >> for more details...
Electricity sometimes can be dangers , sometime got shoked
form it . It is because of volatge or Current
- 6 Answers
- 9909 Views
- Kirloskar, I also Faced
- E-Mail Answers
Answer Posted / nithi
shock is depending on the amount of current flowing through
our body not on voltage (whatever the voltage level,it may
be even from 30v to some 100KV).
Again, the current thr'o our body depends on
the condition of body (dry or wet).
so,voltage doesnot have effect on shocking. if
the current exceeds the permissible limit ,then we will get
shock.
for example,we can touch even the power line which is
operating with the voltage of 765KV ,PROVIDED
1.SAFE CLEARANCE B/W GROUND & THE LINE.
2.GOOD CLEARANCE B/W THE TOUCH LINE & THE NEARBY LINE.
EX: crow doesn't get shock whereas peacock gets shock.
| Is This Answer Correct ? | 23 Yes | 2 No |
Post New Answer View All Answers
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
How to know vacuum in vacuum cylinder of breaker in working condition
working principle a.v.r. ?
what kvrah y we need to take the readind of that
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
how the aircraft outer body and inner body is separated ?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
how can we change the phase angle b/w two phase?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
take 100kva DTR( delta/wye ), what ll happen if we connect 11kv to LT side instead of connecting to HT side? will the DTR behave as a step up transformer or something else????
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
