Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between: throttle valve,flow control
valve, venturi??
- 1 Answers
- 12673 Views
- I also Faced
- E-Mail Answers
Answer Posted / bal ram gurjjer
throttle valve is a choking which is used for rgulate of
power of engine by supply of fuel,and venture valve is a
nozzle throught which fluid flow,and control valve is used
for control of supply at inlet or outlet
| Is This Answer Correct ? | 12 Yes | 7 No |
Post New Answer View All Answers
How to stop a purifier?
low of heat transfer
How is natural gas better than lpg?
Do you work for many hours each day?
Sketch the jacket cooling system?
Why are open the ejector air vents.
What is the meaning of probe in Boilers and that stuff?
Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards
What is the relationship between hardness and tensile strength?
How to check the round duct measurement
What is a turboprop engine?
Which impurities form hard scale and which impurities soft scale ?
hi this is ravi , i was short listed in hal assistant engineer, now im going for interview can anybody help how is the interview for mechanical stream very urgent if anybody knows forward to me my mail id i.ravibabu2@gmail.com
alignment formulae for any two shafts for shim correction
Which are the sheets of metals?
