Answer Posted / ns
The question can be mean different way.
One answer is as follows. depend upon the valve actuator
can be consider two types. AIR FAIL TO CLOSE and AIR FAIL
TO OPEN.
Is This Answer Correct ? | 22 Yes | 3 No |
Post New Answer View All Answers
Area classification, Equipments, Gas groups, temperature classification, Ingress protection, Fire Extinguishers.
this site is owned by an nonsense
I have got a call of IOCL interview for projects having 2yrs experience. What sort of questions should I expect in the interview?
HOW TO SOLVE PROBLEM WITH ENRAF LEVEL TRANSMITTER 854 ATG THAT PASSWARD DO NOT Exist INTO TRANSMITTER TO ADJUST LEVEL WITH PORTABLE PET 847, WRITTEN WRONG PASSWORD , I AM SURE THAT DEFAULT PASSWARD (W2=ENRAF2) IS THIS TRANSMITTER NEED TO REPLACE SOFTWARE AND HOW?
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
how to calibrate 0- 150 psi presure gauge by dead weght tester
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
Reason for capillary type dp level transmitter fluctuation
send me HPCL paper
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
key phaser where is use and work
Questions on flow meters,few questions on HART protocol,