Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kapil
harmonics are produced due to non-uniform distribution of
flux,due to the voltage waveform get distorted.therefore
the output obtained isn't desirable
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What is cathode ray oscilloscope (cro)?
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
What is inverse definite minimum time lag relay? Where is it use?
'documenˁ
1.WHAT IS A SMART CAPABLE DB ( DISTRIBUTION BOX) ? 2. HOW TO DECIDE THE TYPE OF DB TO BE USED ( RECESSED/ PLUG TYPE/ SMART ETC ETC? 3. WHAT IS MILLENEUM BUS BAR USED IN DB? 4.DIFFERENTIATE MCCB AND MCB.
How do you compute voltage drop and cable size over distance?
What is EMC filter in VVVF Drive ?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what is high and low cut off voltage of BB and DG at SPS????????
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
xfhnchncv?
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
what is the difference between pvc & fiber glass cables
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
Explain how you intend to work under pressure to meet up with deadline target?
