Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...

Why power factor is arising in electrical circuit, is it
possible to eliminate from the circuit, why

Answer Posted / prajeesh

Power factor means the leding of lagging currents... It can
be maintained near to unity by using capacitor pannel if
lagging n motor if the current is leading....

Is This Answer Correct ?    0 Yes 2 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

what is the condition for YnD11

2497


Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com

2081


why all the feeders are designed in a particular manner ... is there any reason for that???

1903


Advantage of LT panel vs HT panel

2848


from where the self excitrd induction generator get the power?why is the voltage regulation is poor of seig?

2199


in 132kv substation CRT means

2568


How i can calculate current of cable according to ares?

1921


sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.

2880


What is the difference between solid grounding and impedance grounding?

2028


how can i get the formula to find out the cable size if i know the load of main fuse protection.

1887


I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?

1886


what is maxemo work permit procedure

2148


how to calculate singlephase motor efficiency?

2176


Earth leakage relay basic knowledge principle

2128


What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?

2125