Interested to Buy Any Domain ? << Click Here >> for more details...
How to Calculate the current drain in the battery (1.4V)
for the 2mins time period?
- 7 Answers
- 9435 Views
- I also Faced
- E-Mail Answers
Answer Posted / prajeesh
Current drain depends up on the load
connected to that cell and mode of connection(if parallel or seiries) and Ampere Hour of the cell....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the difference between AC and DC injection methods for rotor earth fault protection
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
size of condotory fron voltage level
what is distribution board?
how does grading rings & spacers in transmission line works? Working Principle?
how many Classification of fire extinguisher
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
What is the previous name of Cox's Bazar
Is the theorem applicable to ac sources?
Grid fault level [KA]?
what is breathing?
Tell me in detail about c.t. And p.t. ?
What are test values for an 63 KVA and 100 Kva Distribution Transformers for the following typical tests 1)Magnetic balance 2)Short circuit test 3)Open Circuit test 4)Vector group confirmation test .please give me the standard values for all the above tests.
What are high pass filter and low pass filter? and What are the flowmeter ?
What is the formula formula for Busbar sizing and what are the things to be consider for Busbar Calculation?
