Interested to Buy Any Domain ? << Click Here >> for more details...
How to Calculate the current drain in the battery (1.4V)
for the 2mins time period?
- 7 Answers
- 9210 Views
- I also Faced
- E-Mail Answers
Answer Posted / vijayakumar(kseb, pallam)
Questions is incomplete. Current drain depen on the load
connected to that cell. THANK U FOR ASK ME.....
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
What is turn ratio of a transformer?
Draw the circuit of clapp oscillator?
WHaT IS THE CONCEPT OF INDUCTION LAMPS IN MODERN LIGHTINGS, and HOW IT WORKS TO EMIT LIGHT ( AS NO ELECTRODES ARE PRESENT ) ?" COULD INDUCTION LAMPS CAUSE INTERFERENCE WITH COMUNICATIONS INTO A STORE USING INDUCTION LIGHTING ? WHAT IS THE BENEFIT OF USING THE LOW FREQENCY INDUCTION LAMP , VERSUS LED , AND VERSUS FLUORESCENT, AND VERSUS ANOTHER KIND OF LIGHTING . THANK yOU MOISES GUINDI
all details of DG UPS HVAC
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
How to calculate per unit impedance of transformer?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
What is an iron loss or core loss pi?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
What is the working principle of servo motor? And explain it.
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
What is mason's gain formula?
