Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rakesh kumar
An inverse definite time minimum relay as the name suggests
shows a an inverse behaviour that is the operating time is
inversely proportional to the magnitude of fault current,
however the operating characteristics become constant once
the pick up value of the relay is attained , this is
achieved by using a core material that saturates at the
pick up value of the relay
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
What’s electric traction?
what is power factor ? how we can calculate the low power factor and amount of capacitor for improve that low factor ?
is there any current and voltage drop on liquid resistance starter water/soda tank ?
which cable is used for 15 Hp monoblock pump 3phase and service wire Distance is 210 feet please tell me cable size Armaured
when the time of backcharging the transformer three phases only enough or three phase with neutral is must.from these which one is the best one.
What are the functions of temperature scanner in power transformer?
Is it a better option to procure screw type air compressor rather than reciprocating air compressor?If so, what is the reason?How should we select an air compressor(100 CFM)? Please mention the important parameters of air compressor.
what is the pre charge circuit,what will be work which function it will be use plz tell me
WHAT IS THE CURRENT CARRYING CAPACITY OF 2.5/3 CORE HI TUFF CABLE,WILL IT SAFLEY CARRY 8.6 AMPS OVER 120 METRES,CAN YOU ALSO ANSWER WITH FORMULA FOR WORKINGS OUT ,THANK YOU 3RDYR APPRENTICE.
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
please send me previous year questions of jspl through which i could prepare myself for the test.
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
