Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rakesh kumar
in parallel resonance the power factor of the circuit is
unity as the reactive current drawn by the circuit is 0,
but the impedance of the circuit is maximum in parallel
resonance as the line current is minimum at this case . the
overall impedance at parallel resonance is l/rc, where lis
the inductance and c the capacitance having the dimensions
of ohms .
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
where was current transformer protection units used and why??
what will happen if i connect 12 volt battery with 24 volt battery charger.
How much minimum insulation required between 11kv/3.3kv transformer windings?
what is the relative size of single and three phase?
Why is a synchronous motor always star connected??
if two transformers are placed parallel & both have fault impedance of 50KA will it increase or decrease show example?
A generating system will have a total capacity of 300 MW. Find the probable forced outage when the capacity is supplied by two 150 MW units. The operating probability of all units is P=0.98 and forced outage probability rate Q =0.02 .
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
state the working of discharge lamp?
What is non-minimum phase transfer function?
Would you recommend to replace all oil filled cables with xlpe cable for hv transmission with the current technolgy for xlpe cable?
