Interested to Buy Any Domain ? << Click Here >> for more details...
1 sq.mm alluminum cable hou much current caraing capacity
- 5 Answers
- 11565 Views
- I also Faced
- E-Mail Answers
Answer Posted / raju
Approx. 1 Amps only
| Is This Answer Correct ? | 10 Yes | 10 No |
Post New Answer View All Answers
Why we use ups battery and dsdb battery in thermal power plant
A ray hit a smooth regular surface at an angle of 20 from the normal. Calculate : 1. The angle btw the incident and reflection ray. 2. The angle of deviation.
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
Why strting torqe high in inducation motor?
i want to know about torque of slip ring induction motor
How much kv gas generator is needed to run 2 hp and 1 hp airconditioners, plus a refrigerator and 4 Tvs
How isolater function when installed inelectrical 440V wiring
what is the correct format to create a resume for interview??
why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?
Draw the line diagram of diffretial relay connected to transformer?
how we explain parallel paths armature winding?
What is meant by coupling capacitor?
What is meant by impedance? difference between high & low impedance ?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is BusBar integrity test and how it is conducted?
