Answer Posted / ravikumar ts
Fuses : fuses break the circuit when only short circuit &
over current flow in the circuit.
Breakers : break the circuit when over voltage, under
voltage, earth fault, over current & its very sensitive.
Fuses : most of the fuses used only at low current rating &
not using at LT panels.
Breakers : its used more high current ratings & using at
all LT panels.
Fuses : fuses made up of Bismuth, Cadmium, Silver & chana
clay.
Breakers : made up of totaly mechanical systems & trpping
coil, closing coil small motors etc.
Fuses : its take very small space to connect
breaker : its take more space to connect.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
What is slip in an induction motor?
witch pump used in wtp
I WANT TO know WHICH WAY IS BETTER FOR CONNECTION BETWEEN POWER TRANSFORMER AND MAIN DISTRIBUTION PANEL. 1-IS BETTER WE USE CABLE? 2-IS BETTER WE USE BUS DUCT? my transformer rate power is 2500KVA
what is the criterion for selecting vector group of Transformers ? i mean how to decide vector group of Generator transformer, substation trasformer and transformer at consumer end
how to decide the panel size like MDB ,SMDB PANEL SIZES
I use 20 nos led tube 4feet, in pathway 100mtr approximate, so what size cable i use for lighting
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
how many electricity poles are there and what are the names and their sizes.
why Lightning arrestor are made by 2 seperate stack of inslutor but why cvt are in single stack of insulator.
what is the stear deltaprinceple?
lenz law application and define
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
what is physical distance of isolator to VCB in 33/11kv sub stations
state the working of discharge lamp?
please forward me the type of questions which would rise while me attending to 33KV Electrical License to my mail ID:vadrevu_raghava@yahoo.co.in