Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / sethar12
Can we supply AC from UPS to control circuits?
| Is This Answer Correct ? | 4 Yes | 6 No |
Post New Answer View All Answers
what is mean by PIR in circuitbreaker and give me detail of that?
how to calculate
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
If one lamp connects between two phases it will glow or not?
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
WHAT IS DEAD END IN PROTECTION?
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
How will you justify IR value and Charging voltage of any motor,transformer and Cables.......???? . . . . . . . . Plz tell me any body Baljeet Singh, engineer_89@refiff.com
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
Why derivative controller is not used in control systems?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
