why the tapping of transformer on ht side??????
- 12 Answers
- 38650 Views
- CTS, OPTCL, Visa Steel, I also Faced
- E-Mail Answers
Answer Posted / sumit sen
number of turns is more in ht side and also current is less
| Is This Answer Correct ? | 3 Yes | 6 No |
Post New Answer View All Answers
if the number of poles generated in stator and rotor side of an induction motor are different then what will happen and why?
what is the differebt between ac and dc fuse?
How to know any size of cable if there are not written on cable? Answer must be theurical not by experience.
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
is it possible to start a motor in felid connected to a remote mcc
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
Y phase plates are used in transmission line??? what is there need???
What are the factor to be consider for CT selection in 132kV substation?
How to know of any cable size if there are not written on cabl?
Any Electrical Engineering jobs?Please refer for interviews. Thank you
size of condotory fron voltage level
l&t switch FN 63 handle position can we change
previous year paper of ntpc bhel for degree in electrical enng
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
For overhead protection we use which transformer?
