Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / raza
Earthing is the term which is first used by UK, where
grounding is the term which is first used by USA. There is
no difference between them.
| Is This Answer Correct ? | 0 Yes | 8 No |
Post New Answer View All Answers
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
how to calculate current and voltage in a same circuit?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
what will be the min and max voltage flow from neutral to earth?
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
Starting Time of LT & HT Motor
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
What is the effect on 3phase induction motor if current setting knob of DOL kept at minimum current?
What are operating procudures & Safety precautions to be observed while operating OLTC in manual mode ?
What is making & breaking current ???
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
Why there are some equipment(i.e:TV) that using 2-pin plug instead of three? What happen if there is current leakage? Are we going to get electric shock??
What is magneto on a gas generator. how it functions. its out put is d.c or a.c. how it can be checked for correct functioning
