Interested to Buy Any Domain ? << Click Here >> for more details...
why electric shock due to dc is dangerous than that of ac
- 44 Answers
- 68531 Views
- I also Faced
- E-Mail Answers
Answer Posted / arul
Mr. Pardeep. U Need to be more aware of Electrical Shocks.
U Made a point that DC is not dangerous, If so then Why
Capacitor Banks in Power stations are being isolated
completely from the reach of Man..? My point is DC is more
Dangerous as comparred to AC. In accidental contact with
High Voltage DC source, the living body gets attached with
the strong attractive force where the Biological ionic
cells gets attracted towards it. Where as in AC, one of the
two half cycle helps the body to repel out from the AC
source. i.e the Body will be thrown out with an axtreme
force. Perhaps, this may not lead to loss of life unlike DC.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
hi i have applied for lic of india south cenrtal zonal ,hyd. i didnt get hall ticket till now.let me know how can i get form internet
why using transformer and thyristor switch in 3 phase apfc panel
IN dc capacitive reactance is??
What are the conditions to be satisfied for parallel operation of dc generators?
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
is it possible to say motor horsepower number without seeing name plate(when name plate damaged)
Define open loop control system.
what happen when power factor of 2 parallely operated transformer become equle?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
Write down the design procedure of commutaj.
how can decide the current rating of oltc
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
how we can calcultae the short circuit level for bus bar
