Interested to Buy Any Domain ? << Click Here >> for more details...
how to select a cap,when a fan is required 2.5 micro ferad
cap,then how we know about 1 hp motor?
- 1 Answers
- 3694 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
A fan is of 40W to 60 W.1 HP motor is of 750 w ,but current
drawn is also dependent on pf.Hence minimum 50 mcf
capacitor is required
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
What is Delta Connection? What is meant by Forward Delta & Reverse Delta & How Will be the Connection in Power Transformers?
What is the formula to calculate the size of Aluminium and copper cable?
ELECTRICAL ENGINEER TEST IN FEWA ANY ONE HAVE KNOWLEDGE ABOUT THIS?????????
which phase is preferred for connecting 1 phase vt used for synchronizing OHL? WHY?
What is evaporator & condencer & compressor
What is Scheme Test of High Voltage Switchgear. Which tests it includes.
On what cycle does thermal power plant operate?
How maesure earth neutral value & how much maximum value value required in between earth & neutral.
why we use two slope(differential & restraining) in differential relay.but in busbar protection differential we are using only one slope?please explain
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
What is 11 N1 and 12 N2 in single phase Transformer ?
draw the restricted earth fault protection circuit install on power transformer and identify its parameters and draw C/C curve of it
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
