Interested to Buy Any Domain ? << Click Here >> for more details...
Why power factor is arising in electrical circuit, is it
possible to eliminate from the circuit, why
- 2 Answers
- 4549 Views
- I also Faced
- E-Mail Answers
Answer Posted / vinodsukku
power fator is developing wherever magnetising power
developing, it can not be eliminated ie, in motor
electrical energy is converting mechanical energy through
flux , the production of flux is the cause of reactive power
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What are the material used for inductance coil?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
what do you mean by class PS CT and what are technical details needed for calculating it?
whati s the sludge current in ups
Anybody know how schematic diagram for reverse power relay? RPR for generator protection
how we find transformer capacity by ohm
what is the value of combined earthing in general electrical circiut?
What fomula is used to calculate: 1. rated frequency withstand voltage, and 2. rated lightning impulse withstand voltage.
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
Single line digram for 11 kV to distribution use go,la and do
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
what is load vs Torque curve & why it is used?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
