Interested to Buy Any Domain ? << Click Here >> for more details...
What will be cross section area of copper conductor for
carry 2000 amps & 2500 amps....sq.mm.?/
- 3 Answers
- 7235 Views
- I also Faced
- E-Mail Answers
Answer Posted / rakesh kumar
it is given by the formula
I=3.2D^1.5
WHERE
I=CURRENT IN AMPS &
D=DIAMETER OF CONDUCTOR
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what are the preventive maintanance actions taken for air circuit breaker? please answer me
what is formula for zero phase sequence of nuetal earthing transformer of 6.6 kv
Why we use duplex coil and hook switch in telephone system?
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
please send me previose rrb junior engineer qustion papers
Define liftable weight of a transformer? Does the total weight of transformer include oil weight?
why the difference arise between HT reading & LT reading (submeters fixed in complexes, apartments etc)if the power factos exceed from 0.9 to 1 can the ht meter reads fast?
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
it is possible to rotate the DG engine dc starter with wrong polarity connections? why?
define superposition theorem thevnin theorem ,norton theorom?
my b-tech percentage is 50%. what answer will satisfy the hr ?
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
at which voltage level arcing ground is occurs ??????????
