Interested to Buy Any Domain ? << Click Here >> for more details...
why onlyseries motors are used as universal motors? why not
shunt?
- 4 Answers
- 11151 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / qureshi majid
Shunt motors are started directly through line,which may be
damaging to the armature and they need special starter
avoiding said damage,where as series motors have high
starting torque with load.without load, starting must be
avoided because empty running can get very high speed
exceeding limit may cause serious damage to the system .
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
why US countries maintains 110v and 60HZ
What current flows in the transformer primary when its secondary is open?
I am designing new project sub station with 220 kV / 11 kV, 40 MVA capacity. This project have many recifier sets, which can generate 3rd harmonics. Now I have to select vector group of This transformer. To minimise 3rd harmonics, what care should I take in selection of Transformer Vecrtor group? If it is Y-Y with open Delta tertiary then what should be the rating & voltage of Tertiary Winding?
What is line resistance of cable & how it can be measured ?
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
what is difference between speed mode and torque mode in motor?? explain in simple words please.
Explain what is electric traction? Explain few advantages of electric traction system?
explain different types of d.c motors?
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
what is the difference between delta delta and star delta connection transformer? why we use delta delta transformer since it need earthing transformer for grounding?
how to choose cable size with respect to load? how to convert cable size in mm2 to sq.mm?
Difference between RCCB, RCBO and ELMCB.
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
How do i right a ladder diagram that has 1 actuator that performs a full stroke followed by a half stroke
