Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / k.prakashchandra
Touch voltage is the voltage drop between the ground and
the conductor above.Step voltage is the pd along the ground
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What are the three constants associated with a steady state error?
What is acsr cable and where we use it?
Can we use both Electrical & mechanical interlock between tow breakers? if yes how, please explain
what is acceptance test in electrical engineering.
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
Define steady state error.
pls tell me function of closing coil of A.C.B.
Differentiate between Zero and Negative sequence current
what is the difference between switch yard to residential area.and how much required it.
Please brief me about number of pole in alternator.In single phase alternator coils are connected in star or series. How to calculate frequency for the same.
What is pi controller?
Hi,iam a diploma in electrical engineering.rtd from indian air force in apr 2007.prsently working in reliance next link as a network maintenance engineer since 2007,can i get a job in motherson sumi.
How you give clearance to a spare feeder.
