Interested to Buy Any Domain ? << Click Here >> for more details...
how would you come to know if a transformer is double wound
or auto? note that there is no tag. you are given only a
multimeter.
- 5 Answers
- 17518 Views
- I also Faced
- E-Mail Answers
Answer Posted / ogeerster
WEll in an autotransformer the primary and secondary windings are electrically connected. So if an open circuit takes place across the secondary winding, the primary voltage shows in the secondary winding. (test it for yourself)
While in a double wound transformer, the primary and secondary windings are not electrically connected, so if an open circuit across the secondary winding occurs, the secondary winding will not be affected.
I hope i have helped.
Regards
Aaron Ogeer
Certified City+Guilds Electrical Technician.
| Is This Answer Correct ? | 4 Yes | 3 No |
Post New Answer View All Answers
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
What cmos is and its benefits?
What is slip in an induction motor?
WHAT IS THE FORMULA FOR CALCULATING CURRENT RATING(DIRECT IN GROUND OR AIR) OF ARMOURED(XLPE) CABLE OF 4C,16Sqmm?
A 15 kw squirrel cage motor having a maximum efficiency of 90% on a continuous full load has temperature rise of 42 degrees celcius after 30 min and 52 degrees celcius after 1 hr under the above operation conditions. a) calculate its final steady state temperature rise on continuous load and the heating time constatnt. b) if the motor is operated on a short load for 9 min estimate its temperature rise. c) calculate the maximum overload that can be applied on a short, 9 min rating so that the temperature rise is the same as the final steady state temperature rise on continuous load.
should %impedance be high or low in a power transformer? if so why?
What is the formula for calculating impedance of transformers connected parallel at fault level 50KA?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
Why we use ups battery and dsdb battery in thermal power plant
what about electrical pannel.? What is meant by plc pannel.?
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
In Plumbing services What are accessories we consider for a bathroom?
what is the chiller and working principal
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
How servo stabilizer works.
