Interested to Buy Any Domain ? << Click Here >> for more details...
Why the frequency of a system is changed if the load changes?
- 5 Answers
- 13947 Views
- I also Faced
- E-Mail Answers
Answer Posted / shiv sharma
frequency control is the difference b/w generation and
load ,if your load is greater than your generation then
frequency would decrease and similarly if your generation
is more than your load ,frequency would increase.If both
values are equal then frequency would remain stable i.e 50
hz in india.
Regards,
Shiv
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
How to decide cable tray size?
I have a small system with two motors that are running on 380 vac, 60 hz. These motors are expensive and I usally get them from Brazil. I am adding another motor to the system, but I want to purchase a 480 vac, 60 hz motor to use. It will be on a VFD that is rated fro 380 thru 480. Is this posible and will I have to use a larger motor and derate it?
what is JE exam?
How time response of the system is divided?
how to differentiate a mpcb,mcb with a contactor? Explain their working operation
Why PT voltages are measured with respect to ground? What do u mean by voltage or current polarized.
how oil in the MOCB was reduced compared with OCB? what are the features of the MOCB?
What is stepper motor. What is its uses?
where lt & ht capacitor used
In Generator How suction compression power and exhaust works ?
why the name trunking bus PT
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
What descriptive information does the NEC require to be marked on all conductors?
