Interested to Buy Any Domain ? << Click Here >> for more details...
we can stepdown the voltage from 230/12v ,and we use the
voltage for various electronics components why can't we
step up the voltage from 12/230v if we can shall we use the
voltage for domestic single phase supply
- 5 Answers
- 9101 Views
- Areva, I also Faced
- E-Mail Answers
Answer Posted / ashish
if you are going for a step up voltage then the voltage
source at lower level (in this case 12v ) has to be very
strong i.e the 12v side should be able to feed the high
current rating of the equipment connected to 230v such as
AC, fridge, water heater , mixer, microwave etc and imagine
if few of the equipments are running at the same time then
amount of power required which the 12v source has to
provide ...its difficult...
and also in such case the insulation level, the conductor
size etc has to be worked out for ECONOMIC point of view ...
its difficult..
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
what is the significance of tan&delta and how it performed in power transformer
how the characterstics of control valve being done
On what cycle does thermal power plant operate?
how to calculate cable size in diffrent loads?
What is limitedly stable system?
HOW TO CALCULATE HV TEST VOLTAGE FOR ELECTRICAL EQPT.
If any one's require of phoenix contact like( relay , termilnal block , surge protection device ) , product please contect me 09878206357 chetan verma
Why the efficiency of a three-phase induction is the motor is less than that of a three-phase transformer?
Mention the disadvantages of low power factor? How can it be improved?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
What is FM200 Gas??Applications........
how to calculate singlephase motor efficiency?
pls someone send me sample question papers along with the key.thanks in advance
why i can not use thimble on capacitor duty contactor
How one may guess the direction from which the distribution line is incoming if there is no pole plate on poles?
