Answer Posted / rajiv mahajan
single phase preventer, over load relay, mpcb, mcb
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
direction of tarbine& genrator
The advantages of Magnetic flux leakage technique over Ultrasonic technique for non distructive testing of material.
How to know about the rating(voltage and other) of induction motor if its name plate is missing at the manufacturing site.
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
Why derivative controller is not used in control systems?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
where does 22kv line starts
which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?
What are high pass filter and low pass filter? and What are the flowmeter ?
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
What are the limitations of Kirchoff's laws?
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
What are the basic properties of signal flow graph?