Interested to Buy Any Domain ? << Click Here >> for more details...
how to use one 4-20mA signal for two indicater or controller
& give necessary precaution.
- 2 Answers
- 4815 Views
- I also Faced
- E-Mail Answers
Answer Posted / belal
24vdc output of transmitter will be connected in series
with two indicator , don't connect in parallel otherwise it
will be dammage
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
protection relay watchdog contact operation?
find the kp ki kd from the transper function G(S)=29.44s+04707/1.5349s2+s
What is difference between ESD and PLC please Explain me clearly.
what diffrence b/w plc s7200,300,400
what is The specifications for oriface instalation
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
If fire would be inside the plant which fire detector is to detected the fire.
What is loop1 and loop2 in MTS LT?
Hi Friends i am going to write BARC written test by this month 20th (20-5-2008). So please if any body knows the details about this or having previous question papers pls mail me to kkumarei@gmail.com. For Suggestions give one message to 9962122264
In Safe Guarding test what means by "Failed to Danger" ?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
