Interested to Buy Any Domain ? << Click Here >> for more details...
How many input(Analog and digital) and outputs(Analog and
digital) are there in DELTA v DCS Version 7.0?
- 2 Answers
- 5739 Views
- I also Faced
- E-Mail Answers
Answer Posted / ameyajoshi12
2500 io
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
for oil & gas industries which zone is normally preferred? why? give its example?
Type of level transmitter commnly used in Procees area are the following. a.________________This type of level transmitter works as follows
why Fahrenheit unit of moistur analyzer transmitter
Explain the working of rota meter.
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
hello can yoy pls send me previous papers of jindalpower and steel ltd.....'m from instrumentation..... mani1048@gmail.com
If P will increase then what will happen with PID?
ORP sensor working principle?
what is droop in governer ,type of droop ,how it work
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
What is rang ability?
How to measure the dust in chimney(spm)?
What is the use of double seated valve?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
