Interested to Buy Any Domain ? << Click Here >> for more details...
Why in screw & centrifugal compressor using rolor bearing
- 3 Answers
- 7652 Views
- Johnson Controls, I also Faced
- E-Mail Answers
Answer Posted / guest
due to point loads in bearings and rotary mechanism
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
Draw L.O. system in diesel engine?
what is mean by cc critical characteristic, hic high impact characteristic
What are the causes of steam turbine failure?
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
i am studying mechanical engineering third year.. i want to study ine year marine bridge coure.. is that good for me?
Differentiate between the uniform flow and non-uniform flow?
What is orthographic drawing?
what is the technology used in sap?
If mft not act when spark failure 3 time what problem will happen in boiler side
What causes crankcase explosion?
Who built the tr alaska pipelene?
Is IS 2062 different from ASTM A 36 or both are almost same
why the path of a satellite is always elliptical with earth not at the centre of the ellipse?
How is ceramic defined ?
