generally the electrical equipments not to be operated at
leading power factor, why?
- 2 Answers
- 3763 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjeev parekh
because generally all electrical equipments are inductive
loads.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
What is the difference between diesel generator engine with and without turbo charger with the same capacity?
How npn and pnp transistor works
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
Explain what are inter-poles and why they are required in a dc machine.
What is the method of estamating of cable, CB,MCB ?
Mention what are the different colors on wires indicates?
while doing high potential for 11KV 3 core cable how much leakage current will obtain?, what will be acceptance value?
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
what is meant by k-rating in isolation transformer?what is k9, k14 stands for?
Why do power lines not short out when they fall into water?
What is “pu” in electrical engineering?
What are the internal and external faults?
What are the advantages of a three-phase system over a single-phase system?
why are u join ntpc
