Interested to Buy Any Domain ? << Click Here >> for more details...
How can you measure the signal from the PT100 sensor?
- 1 Answers
- 5502 Views
- I also Faced
- E-Mail Answers
Answer Posted / sri
The Temperature PT-100 sensor is a Platinum resistance
thermometer (PRT) which offers high accuracy over a wide
temperature range (from -200 to 400 °C). The Platinum
resistance thermometer (PT-100) has a resistance of 100
Ohms at 0°C, so it called as PT100. it offers 138.4 Ohms at
100 °C. The resistance changes (fearly linear) with
temperature are: 0.385 Ohm/°C.
by using a wheatstone bridge we can measure the change in
the resistance, which is in the form of voltage.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
Is there any standard guidelines/Criteria to design NGR/NGT.?
how to size H.T & L.T Panel ?
Define availability (operational)?
Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control
For overhead protection we use which transformer?
HOW TO CALCULATE CAPACITOR BANK OR HARMONIC FILTER CALCULATION
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
how to failure indution motor insulation & how to improve heat in motor insulation
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
What are the types of control system?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
