Interested to Buy Any Domain ? << Click Here >> for more details...
what is tertiary winding in transformer?What is its purpose?
- 18 Answers
- 106040 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / sri
some more information about tertiary winding
ref:
http://answers.yahoo.com/question/index?qid=20090731083908AADwAY1
One purpose may simply be to provide an additional terminal,
often at a different voltage. While the use of 'three
winding transformers' is relatively unusual, it can be a
powerful tool is system architecture.
The other objective for a tertiary winding is to provide a
closed-circuit path for zero-sequence currents/fluxes. That
is most typically the case with transformers that, for
system reasons, must be connected wye-wye (star-star for
those in the IEC world). With a wye-wye transformer, the
only path for zero-sequence flux is the tank of a
transformer (and if the three-phase bank is comprised of
three single-phase units, even that does not exist). The
tank is a high-impedance path, so the result is that the
zero sequence impedance seen looking into the transformer is
very high. Also, the circulation of zero sequence current
through the tank will cause the tank to heat and lead to
paint failure. A tertiary winding presents a low impedance
path to zero sequence currents, thereby reducing the zero
sequence impedance presented to the outside world, while
avoiding the problem of tank heating.
| Is This Answer Correct ? | 19 Yes | 3 No |
Post New Answer View All Answers
66kv under ground cable how to layaing in ground any special case two ckt r runing
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
State norton’s theorem?
we have 15 ampere variyac but we want 30 ampere variyac what we do
what are the things that can cause a three phase motor to crawl?
state the disadvantages of carbon filament???
can i use 2000/5A Clamp meter to measure HT cable
1.What will be stored in online ups EPROM IC?
what will happen reduce the transformer voltage from 415v to 406v, is it save the energy,? are this methodis good to reduce the energy.?
Draw the single line diagram of the power station?
Can anybody just suggest about the scope of Electrical design with ETAP software?Just guide me?
I am inpecting a 10kVA UPS what tests should i do and should i observe?
What are locations arc protection relay is fixed.
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
