Interested to Buy Any Domain ? << Click Here >> for more details...
why we use 250 ohms across HART CALIBRATOR DURING
CALIBRATION OF TRANSMITTER
- 4 Answers
- 10736 Views
- I also Faced
- E-Mail Answers
Answer Posted / sankar
Loop Impedance required for communicator will be minimum
250ohms
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
Q-Explain the different load conditions that will produced different offset which may or may not be acceptable to thhe control function
please send me the inteview questions in IOCL
what are the steps I have to deal with?
Q- What are the application in which PNP transistor is preferred over NPN ?
i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
Any one can help me to identified, how can we interchange the device in FF
SOME OF YOUR QUESTIONS ARE NOT MAKING ANY SENSE SO TRY AND PUT IN A LITTLE BIT MORE EFFORT BEFORE YOU POST A QUESTION. WE WILL ONLY HELP THOSE WHO WE CAN SEE ARE TRYING TO HELP THEMSELVES.
how works encoder in plc
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
how to calibrate 0- 150 psi presure gauge by dead weght tester
Can anybody tell me how to select the size of earthing cable for DCS & PLC system.Please tell me any relevant answer here or mail it to me.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
