Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinakar
50hz is better than 60hz because...by increase in frequency
electromagnetic radiations may occur and also transformer
efficiency decreases
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Pl. share your experience about industrial-electronics repair of machine tool.
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
can we install HT panel & LT panel side by side or how much clearance is required ?
How the circuit breaker is selected for Induction motor of 100 kW, 415 volt, 0.85 power factor, 0.95 efficiency ?
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
how to select electronic timer(Star-Delta) setting for diff. rating motors
What are the various types of rotor used in the alternators?
What are chief characteristics of state-space method and its techniques ?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
33kv Rated output avilable in market (any where in india)
Why do we avoid electrical conduits in floors at apartments?
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
