Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shunmugapriya
M20-compressive strenth of concrete,
fe415-tensile srenth of steel
| Is This Answer Correct ? | 25 Yes | 6 No |
Post New Answer View All Answers
What are the applications of modulus of elasticity?
List out some of the common problems that architect have to tackle it?
what is called Bulk Density of aggregate?
in one SQM plaster how much Cement and sand consumed in ratio 1:4
As per Kandal suggestions, we have implemented rolling starts on 140 (+/- 5) degrees and we kept 3 rollars to complete the rolling before falling 125 degrees and the Aggregate AIV is below 22. But When the DBM bed is being rolled 3rd high viabration, (Before 1 plain & low ,2 high Viabrations), the aggregate is getting sharp edge agg. projections are damaged. As the literature is said that, the VG-30 Grade having better control the temp. susceptibility than Penetration grade. if so we could not get this problem at site. But we are facing on site. let me know.
1. What is coefficient use for calculation of shuttering. 2. What is coefficient use for calculation of reinforcement in one cum of concrete.
can any one give me sample question paper of BHEL at mdansari86@gmail.com as i m appearing for the same exam.
What happens to Load at yielding ?
What are the steps involved in the concreting process?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
How much cement,sand,bricks and water needed for 1square metre brick work?
How do you prepare Material Recovery Statement for deduction from contractors bills?
please what are the required bars for a beams of 6mx6m and 450x300mm, one is continuous and the the second is discontinuous ..Its a commercial building (church)
What is the Maximum %age of Steel in columns and beams ?
IS code for Rolling Margin of steel
