why CFL lamp requires less electricity than a normal lamp?/
- 3 Answers
- 4756 Views
- I also Faced
- E-Mail Answers
Answer Posted / linish
as the frequency of the supply increases the lumen output of discharge lamp also increases as we know with electronic circuit, CFL lamp is getting high frequency supply
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to checked frequency drive output voltages?
What is power factor why we should maintain the power factor unless what will happen
As i want some model question paper in basic computer science and history please send me immediately sir
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
How may I enrol or get admission to your program?
we have 2.2kw,Y,3000rpm motor but 6leads found in TB what happen if we connect in delta?
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
What are the roles and responsibilities of electrical engineer in cement plant
Explain Energy and Power signals?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
explain all the classes with example
What determines the thickness of the lamination or stamping?
