Interested to Buy Any Domain ? << Click Here >> for more details...
what is d main difference between KVA and KWA
- 2 Answers
- 15890 Views
- Charoen Pokphand, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
KVA-Kilo Volt Amp
KWA -Karnataka Wrestlers' Association
| Is This Answer Correct ? | 4 Yes | 30 No |
Post New Answer View All Answers
solor panels arrange some angle,panel is flat fitted energy was produced or not why?
1.main parts of generator? what is used A-check,B-check,C- check? 2.what is FM200 system in data centers? 3.difference between pac,ahu?
Discribe type of fault in DOL and stardelta startor.
sugest any typical project ?
how many load we can take for lighting
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
how harmonics generated in induction furnance? how minimise it?
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
Dear Sir/Madam, I have one questions we have three steam turbines and one Gas turbine and our industry linked with the public network, we have protection system one of the protection is reverse power we can export just four MW only i would like to ask about how to calculate the reverse power. Thank you in advance best regards
How to protect a Dosing pumps/any sensitive equipment (single phase) from surge protection inside a food factory.
How to select the proper VSD to operate high inertial load
Why 11kv to be generated in generation station
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
Why we make earth connection with Transformer Body and What will be the minimum size of copper wire as per code with respect to KVA rating of Transformer?
