Interested to Buy Any Domain ? << Click Here >> for more details...
How to calculate the cable size in sq. mm. when the load is
given in KW?
- 3 Answers
- 9142 Views
- I also Faced
- E-Mail Answers
Answer Posted / ram
FIND OUT FULL LOAD CURRENT OF THE GIVEN EQUIPMENT.
THUMB RULE IS THAT, FOR CU CABLE, IF THE CURRENT IS 6
AMP/SQ.MM THE CABLE STARTS TO HEAT. AND FOR AL CABLE IT IS
2 AMP/SQ MM.
ACCORDINGLY WE CAN SELECT THE CABLE.
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
how to measure earth resistance of a substation
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
How much minimum insulation required between 11kv/3.3kv transformer windings?
Explain the purpose of inductor in an electric circuit?
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
What will be the output voltage of a transformer if it is primarily energized from a square wave voltage source?
What is an ideal transformer?
what is gridrotor resistance starter
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
How 3 phase invertor works?
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
What are dependent sources?
If any HVDC line is going with positive & negative(the negative usually have return path of current with earthing electrode). Now the question is if this HVDC earthed electrode which is using as return path and earthed any nearby 400kv or 220kv AC substation equipments. which will be the impact of this on AC substation & its equipment, how severe may be this and what should be the minimum distance require between HVDC earthed electrode and AC substation equipments? It's really an high engineering level question...Dare to answer and increase your knowledge.
