Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between MCCB & ACB & VCB
Answer Posted / pankaj kumar gupta
MCCB -Molded case circuit breaker
ACB - Air circut breaker.
VCB - Vaccum circuit breaker.
ACB USE IN L.T SYSTEM.
VCB USE IN H.T SYSTEM.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
R=*ΒΆ l/a
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
What is center gravity load in substation?
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
i need to give section engineer (electrical engineer) for RRB. Please suggest some book
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
is it possible to have dc motors on single chip
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
why the starting voltage drop in a cable needs to be limited?what is percentage of the voltage drop allowed during starting?
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
What is meant by impedance? difference between high & low impedance ?
what is the voltage regulation for unity and zero power factor?
