Interested to Buy Any Domain ? << Click Here >> for more details...
How to run 1ph motor(230 VOLTS its full load amps is 4.5
ampa))with 480 volts main(we didn hav neutral)Thn we go for
step down transformer.Our load 10 amps,so we conisder this
amps in primary are secondary side
- 1 Answers
- 3730 Views
- I also Faced
- E-Mail Answers
Answer Posted / h r jadhav
when line voltage 480 is used across the primary of step
down trf having secondary is 230 volts then 1 phase motor
will load same current to lv side however it will load the
primary with respect to tf ratio. so if u have tf rated 10
amp for primary it is welland good.and if it is for
secondary it is well.
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
What are the specifications for conducting earth leakage test as per IEC standard?
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
What is sink and source?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
Pls tell me whether we can use EN3A material for shafts of Permanent magnet alternator.What will be the effect of magnetic and nonmagnetic material for shafts on magnetic properties of PM rotor .
What is process of anneling transformer core
Explain the terms real power, apparent power and reactive power for ac circuits and also the units used.
In a single how much maximum current and watts using
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
what is the difference between single ratio, multiple core and multiple ratio, multiple core ? please explain.
why the neutral point in connnection oscillates?
Importance of fault current in power transformers and how to monitor the same? How is it different from winding temperature?
how line turns ratio changes in 3 phase with change in connection
Define corner frequency?
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
