Answer Posted / avd
DE current is measured through shunt. Shunt is a standered
low resistance. It is used in series in the circuit. Due to
series circuit, load current flows through shunt. Because
of this there will be a millivolt drop across the shunt
(ofcource depending on the current). This millivolt drop
across the shunt is measured and meter is calibrated in
terms of current.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
hi every body i am master student in control engineering and my project is slip control in trains i assumed a Dc motore as traction motor but i don't have characteristics of this kind of motor that is used in train. i want from every body if he or she has the characteristics or information about Dc motor that is used in train give me those information or technical characteristics .
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
what will be the min and max voltage flow from neutral to earth?
what are symmetrical and non symmetrical components in electrical installation.
What is the function of auadag in a cro?
What is meant by analogous system?
What are the types of the glands and difference between single and double compression type of cable Glands.
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
difference between the applicability of nortons and thevenin theorem
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
what is meant by flywheel and its role in retardation test
What do you mean by Frame 5 Gas Turbine as well as Mark II.
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
