Answer Posted / manish_2march@gmail.com
the main difference that exist is in their construction.
1.d.c motor has commutator while ac don't.
2.Direct current or DC electric motors work for situations
where speed needs to be controlled
3.They can have brushes
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
neutral earth resistance testing is it possible for transformer while in load condition
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
Please brief working principle & construction of permanent magnet AC Servo motor
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
what r PID controllers?why they r used?what is there purpose?plz Explain in detail
i have install 750 kva distribution transformer at my site and want to do neutral earthing. what calculations should i follow to determine earthing conductor material and size?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
why generator efficiency is more in swinburnes test?
what is difference between 9kv 5ka surge arrester and 9kv 10ka surge arrester.
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
lenz law application and define
what are the disadvantages in GIS over AIS
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
