Answer Posted / raghu
Transformer power factor is depends on our type of load current depends on pf,voltage and KW.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
diff b/w normal grounding and resistance grounding
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
Why choke coil is connected in series with starter in tubelight??why starter is connected in parallel to tubelight??
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
distribution is maximum done by a)radial b)network c) parallel d)b & c
Draw the single line diagram of the power station?
what questions are asked in the interview for the post of an electrical maintenance engineer in FMCG companies?
What is a DC series motor?
Whats the minimum value for I.R. that can be allowed for HT & LT alternators for operation?
george phenomenon of synchronous machine
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Give the topology of current amplifier with current shunt feedback?
The power supplied to a 33microF capacitor from a 120V, 60Hz source will be
please send previous exams question papers
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632