Interested to Buy Any Domain ? << Click Here >> for more details...
i feel sq. pipe is better than round pipe pls give comment
for this.
advance thanks for reply
- 3 Answers
- 5786 Views
- I also Faced
- E-Mail Answers
Answer Posted / rakesh kumar .n be
i think in both we can get the center point, because in square all sides have the equal length, like wise in circle they have the equal diameter ,so in both we can get the center point..
* round pipe is always used because at the bending the flow is same,but in square at the bending we can't expect the perfect shape there may be some leak , tat's is the main reason i think so. we can't expect the 100% flow into the pipe, error may be around +or- 10%
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
what is difference between fork type and capacitance type level switch. where it is using
What is instrumentation control?
What is the procedure of calibration of Load cell?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
what is intrinscily safe system and where we use?
what is the difference between active & reactive power?
Regarding , there is an air cooler which control the fans(50% of AV FANS) by temperature in outlet , and the louver of Air cooler is controlled by HIC from control system , So if on Air cooler we will consider 2 individual I/P converter or positioner?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
What is difference between ESD and PLC please Explain me clearly.
Isometric drawings are generated during _________________ phase of a project
Programmable Logic control.
Why mixer nd grinder Is example of constant torque load not variable torque load ???
