Interested to Buy Any Domain ? << Click Here >> for more details...
Why two nos. un-tensioned wires are placed inside the PSC
poles used by powergrid in RGGVY works.
- 2 Answers
- 6702 Views
- Bhel, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / p.k.hota
For its positioning during casting.and for more and better
transverse stregth of poles.
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
If only R Phase is connected in 2 pole elcb, n is not connected than it will work or not in ground fault.
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
1.why should we connect the measuring instruments in l.v side in short circuit test of a transformer? 2.why the power factor is less in open circuit test of a transformer?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
What are the types of the glands and difference between single and double compression type of cable Glands.
What is the feedback in the control system?
how to find the resistance and gap volatage of the diode??
What is servo motor and what are different types of servo motor
Hello sir i m student of gtu .what is idp.
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
i completed my DEEE. and i want to electrical c license. how to get it..?
HAI SENT HPCL APTITUDE QUESTION PAPER, MY EMAIL ID IS angus_eee04@rediffmail.com,angus_eee04@yahoo.com
What are the two segments of nyquist contour.
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
any one can explain the stages of a knee point which is taken during ct magnetising curve.
