what is the difference between electrical & electronics
Answer Posted / rajesh bhuria
electronics = signal + voltage
electrical = voltage
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Why control of DC motor is simpler?
HOW TO TEST A LIGHTENING ARREST ER ?
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
why power factor is important?
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
how to select the double earth conductor if 21A full load?
What is the basic principle of operation of alternators/dc generators?
Why we are using only Dyn11 tranformer in distribution system but not using a Dyn1 in distributing system?why not and advantage and disadvantage in both
What is vaccum currcuit breaker.define with cause and where be use it device?
Why the arms of delta in a delta-wye power transmission system are kept constant??
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
what is The difference between national electrical code and I.S.Code (electrical) and what is the value of NEC in electrical engineering field
Why neutral is not used in three phases dol starter
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
How to measure current and voltage in an ELV circuit