respected sir,
sir recentely i have applied for chennai and
tiruvananthapur section enggineer and juniour engg in
electrical dept.
but still i donot get how i have to syart my preparation
and also t the same time i donot know exactly what they r
going to give in the examinations i mean which sections
they r going to give i donot know exactly, can u prefer
whichh books i have to follow and model papers or both
boards
Answer Posted / k.prakashchandra
Be thorough with fundamentals
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the use of iron core in a transformer?
how does the terminal voltage of transmission lines increase when a capacitor is connected???? This happens not only in transmission lines but also in all circuits. How??? When a capacitor is connected in a transmission line, capacitor also takes energy from the same supply. But how is it able to increase the terminal voltage??? Practically What sequence of events happen during increase in voltage???
What is effect of over voltage and under voltage on ACB
Single phase and threephase power calculation
What do you mean by a current transformer?
solar inverters was not connected to the nuteral link .this nutwral possible to any other systems
how did i get the competency certificate as electricle supervisor. iam completed my b.tech.but i dnt have any experince, this certificate is required for applyng ongc mangement trainees. what should i do sir please suggested me
if a 3phase 100kva distribution transformer , 400 v,50 hz, 4-wire system is loaded at 160 k.w mostly 1-phase Lighting & Airconditioning split a.c load what will be the net effect on the power system in terms of voltage, powerfactor, current , efficiency of xformer
what is the thumb rule for determination resistance of resistor?
What are the functions of different probes used in cro?
What are the specifications for getting approval of Substation?
how generator load test is conducted?what are the steps?
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
what is the difference between changer, converter and transformer?