Answer Posted / nhv
generally P, R, S and J type towers are there.
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
how can we calculate the ampacity of the electrical wire/cable. and what are the factors must be considered. pls. elaborate.
why should the primary of transformer be connected in delta in a heat run test?
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
Why increase in current leads to increase in conductor temperature?
how to get electrical supervisour certificate in gujarat
what is the reqirred voltage in HT motor to get full RPM on no load test?
how does a submersible pump work..?
How to operate a ac chilar plant?
How to set the relay,,??
EXPLAIN THE WORKING OF SERIES REACTOR IN HT CAPACITOR BANKS (FOR VOLTAGES & CURRENTS)
how much excitation voltage required to generate 1mw power?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?