Why CTs are connected in star on T/F delta connected winding
side & in delta on T/F star connected winding side for T/F
differential protection?
Answer Posted / k.prakashchandra
To compensate for the phase difference in the primary and
secondary currents
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
Draw the line diagram of diffretial relay connected to transformer?
In a carnot engine with an efficiency of 40%, the heat rejected to the sink at 27 C is 60 kJ, then the heat supplied in kJ to the engine by the sources is
in shunt clippers why a resistor is used in sereis with the input
How to define Kirchhoff current law and voltage law along with simply examples.
What is the different between digital phase converter and ordinary phase converter?
explain the Trip supervision circuit
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
What Should be the value of Vector Surge angle at Tripping and how to calculate it?
Iin ESP why positive is grounded ? why not negative ?
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
at which voltage level arcing ground is occurs ??????????
how can we design robots
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz