Interested to Buy Any Domain ? << Click Here >> for more details...
why we use separate earthing for two seprate machine??
- 1 Answers
- 3882 Views
- I also Faced
- E-Mail Answers
Answer Posted / santiago
when the different potential level exists, we must ground
each voltage level.i.e,
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is the most important precaution in any experiment with d.c. Shunt motor?
after how many spot we must chang secondry cable in portable spot welding gun?
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
what is Fan Control Cubicle
hi frenz,its aswathy.i hve aplied for the hpcl test on feb,pls send the test patern & the placement papers as soon as possible. mail-id :kjaswathy@gmail.com
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
0.5,1,1.5,2.5,4.0.6.0,10,16 square mm electrical wires how much take maximum current in 50htz
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
what is doid
What is d main advantage of using double circuit 3 phase transmission ?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
1.dg on load alarm/stop alarm... 2.dg on load. piu alarm alarm kaise chek krte hai
What is the type of feedback used in an op- amp schmitt trigger?
State kirchoff current law?
1.how many types of relays? 2.difference between ATS& STS?
