Interested to Buy Any Domain ? << Click Here >> for more details...
what is reactive power
is it good or bad for a system
- 5 Answers
- 16538 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravindra
reactive power is only a expression of power factor by the
point of view of power system. as cos x increas means sin
x will decreas . so reactive power provide same information
as cos x. the importance of reactive power comes when in
power system analysis done with p.f expression cos , the
equations
of buses becomes too hard to calculate .so insted of it "q"
expression is used which easy the complex problem. and q can
t be a power bcoz its unit is kvars. its like a jinda lass
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
technically, what is the reason behind starting the motor star the delta connection .. and what other ways to do this rather than using " star-delta transformer"
If we have to feed a housing complex having load 8MVA, than what would be the better option, either we first step down 33kv supply into 11kv & than 430v or we proposed no of 33/.44 kv transformer, also which option is economical?
Can clean earth cable be considered as low current cable
On what cycle does thermal power plant operate?
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What are the specifications for conducting earth leakage test as per IEC standard?
what is a types of short circuit and what is a types of distance protection tests
why they were using TRIAC instead relay in some controllers and what is the advantages.
How is the gain affected by the introduction of feedback in a control system.
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
What is MSL designation of a motor and same may be provided in details.
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
